Pole Attachment Policy

Kentucky Power Company Pole Attachment Policy

General Design Policy

During the design phase of aerial cable plant proposed for installation on AEP/KYPCO’s poles, Communication Companies shall comply with the following policy:

  • Safety is a concern for everyone. During the time of any construction and maintenance, Communication Companies shall consider the electric wires of KYPCO to be energized, that working in the vicinity of the wires poses potential dangers and should warn its Employees, Agents, Contractors, and Subcontractors of the potential dangers.
  • All facilities must be installed in accordance with the National Electrical Safety Code (NESC) and other state and federal laws, rules, municipal ordinances and regulations which apply. The Communication Company must determine the load and sag of each cable to ensure compliance with NESC requirements or AEP Standards, whichever are stricter, are met. This includes the 15’6” fully loaded height requirement over roadways. Please be aware that KYPCO is primarily in the heavy loading area described in the NESC, but will be evaluated under the stricter requirement of the NESC or AEP Standards. Special care should be taken at railroad crossings and roadways.
  • Wireline Pole Attachments are only allowed in the Communication’s space of the KYPCO pole plant.
  • In all situations, prior permission must be obtained from property owners and governmental entities for use of private property and public road rights-of-way. KYPCO assumes no responsibility for securing any such permission that may be required, and Communication Companies should assume no such permission exists based solely on the presence of KYPCO’s facilities. This includes easements, rights-of-way, or franchises required for the construction and maintenance of facilities such as Pedestals, Stub Poles and Anchors.
  • Communication Companies must bond their messenger in accordance with the NESC. If a Communication Company chooses to use a separate bond wire down the pole, it must be bonded to the KYPCO electrical bond at the base of the pole in accordance with the NESC. When grounding at the house, Communication Companies are not permitted to connect to KYPCO’s meter base.
  • Communications cables must be installed on the same side of poles (typically the road side) as other Attachees. Pole Attachments to both sides of the pole (boxing) are not permissible. The installation of Attachments in Aerial Inner-Duct is not allowed.
  • Communications cables must be installed without the use of Extension Arms, Standoff Brackets or similar hardware (unless otherwise approved in advance by KYPCO for each pole, and specifically referenced on the Communication Company’s Authorized Proposal).
  • Communications companies must install their own Guys and Anchors. Use of KYPCO’s Anchors is not permitted. Communication Guy(s) shall be either effectively grounded or insulated.
  • Service Drops are to be taken off the strand at least 15 inches from the outside of the pole using a crimp-on method, not off the pole with temporary equipment (j-hooks, etc.). Attachment charges for each foot of vertical space occupied will apply.
  • Attachments to AEP Transmission poles without Distribution underbuild are not allowed. Consideration for AEP Transmission pole requests will be forwarded to AEP’s Transmission Department for review if requested. All expenses for this review are at the expense of the Communication Company. Attachment reviews on Transmission facilities are significantly more expensive and time-consuming than review typically performed on Distribution poles.
  • Encroaching into the Communication Worker Safety Zone or into the Electrical Space is not permissible, even at road crossings. If the Communication Company is unable to meet any NESC code requirements for clearances above roads, KYPCO may rearrange its facilities, when possible, have others rearrange their facilities, or replace the pole at the attacher’s expense. Measurements are to be taken from the ground up, not from KYPCO’s facilities down.
  • KYPCO recommends the through-bolt method of construction. Loading data and configuration must be supplied and any temporary facilities must be secured to mounting hardware to prevent them from bouncing free of the hardware.
  •  All riser cable attachment requests shall be at the sole discretion of KYPCO. If approved, riser cables are to be in conduit and may be required to be installed on stand-off brackets at the Communication Company’s expense. Risers shall be limited in order to not impede climbing, installed using AEP Standards, and further restricted to a minimum of three (3) spans.
  • Communication Companies shall mark their cables and risers at each pole location with an identifying tag which should include a name and emergency phone number.
  • Communication Companies, contractors, or sub-contractors must possess a signed Approved Proposal or permit from KYPCO at the jobsite when working on KYPCO facilities.
  • DAS antennas/small cell attachers must provide manufacturer’s specs to KYPCO so that any antennas and/or ancillary equipment being considered for installation on/or near AEP poles can be reviewed by AEP’s Standards. Installation of said equipment on AEP poles is contingent upon review and approval by AEP Standards. This equipment review is at the attacher’s expense.

Application Process

If you do not currently attach to our distribution poles, please contact: Lynn Stefanko, Joint Use Representative, at lastefanko@aep.com or (330) 438-7297 to discuss the Kentucky Tariff and application process.

Proposal Process

If you have an active agreement with KYPCO, or are covered by the Kentucky tariff for pole attachments:

  • Submit your Request to Attach via one of the following two (2) methods:
    • Request through the AEP JU Portal at https://aepjuaportal.azurewebsites.net/Account/Login. Access via the Portal can be granted by contacting the Joint Use Representative listed below.
    • Permission to Attach (Proposal) form as identified in the Pole Attachment Agreement. A maximum of 50 attachments on each Proposal is allowed for manageable processing via this form. The completed form and maps may be submitted to kentuckyjointuse@aep.com.
  • Should you require attachment to more than 100 poles, please contact Lynn Stefanko, Joint Use Representative, at lastefanko@aep.com or (330) 438-7297 to provide a current route map and discuss processing timelines.
  • Provide all pertinent information requested including stringing tension, cable weight, and diameter.
  • No attachments, including Overlash, are to be made to KYPCO poles prior to receiving an Approved Proposal. KYPCO will perform a Pole Loading Analysis on each pole including clearances, strength, and capacity.
  • KYPCO recommends the through-bolt method of construction. Loading data and configuration must be supplied and any temporary facilities must be secured to mounting hardware to prevent them from bouncing free of the hardware.
  • Any excavation work, including the installation of ground rods and anchors, requires a call to the local one-call system 48 hours in advance of any digging to locate all underground facilities.
  • All KYPCO pole rearrangements and/or replacement work will be provided as an estimate to your company for review, with approval and payment in advance of work being scheduled or performed as contractually required. A contact for invoicing will need to be provided to KYPCO prior to any Proposals being submitted.
  • Risers, vertical runs, and ILEC multiple mainline attachments must be clearly identified on all proposals that encompass KYPCO poles.
  • All information exchanged between KYPCO, your company and your representatives, contractors and subcontractors shall be held in the strictest of confidence and is considered confidential. Any unauthorized reproduction of AEP information or disclosure of any maps and or documents, in print or electronic format, is strictly forbidden without the express written consent of KYPCO.
  • Notwithstanding approval by KYPCO to construct Communications facilities in a certain manner or at a certain height, it is the responsibility of the Communications Company to ensure that the installation and maintenance of their facilities does not cause a hazardous condition, overload the pole, or otherwise be installed or maintained in a manner that does not comply with the NESC, AEP Standards and applicable law.
  • KYPCO may perform a Post-Construction Inspection of all Communications Company attachments to ensure full compliance with Design Standards. Communications Company facilities not meeting all installation requirements will be corrected at the Communication’s Company’s expense.

Proposal Process

KYPCO currently has approved the use of the following contractors for engineering review of proposals:

  • IJUS
  • UC Synergetic

KYPCO will perform all engineering review using internal resources or the above contractors.

Note: Last updated 3/20/2018

Visit AEP.com
Use of this site constitutes acceptance of the AEP Terms and Conditions. View our Privacy Policy. © 1996-2019 American Electric Power. All Rights Reserved.

Privacy Policy

Privacy Policy for Kentucky Power, a unit of American Electric Power (AEP)


This Privacy Policy applies only to KentuckyPower.com and the Kentucky Power customer mobile app (com.aep.customerapp.kentuckypower). Other AEP websites and apps may be governed by their own privacy policies, appropriate to the uses and needs of each. Throughout the site or app, we may provide links to resources and sites that are not part of KentuckyPower.com or the Kentucky Power customer mobile app. This Privacy Policy does not apply to those resources and sites.


By using this site or app, you consent to the terms of this Privacy Policy. Whenever you submit information via this site or app, you agree to the collection, use, and disclosure of that information in accordance with this Privacy Policy.

Information Collected

  1. Passively collected information

    During your use of this site or app, we may collect anonymous information about your visit here through the use of server logs, cookies, scripts, tracking pixels and other Web traffic tracking systems. This information is aggregated and used to improve user experience through analysis of user activities. This information is never combined with any of the personally identifiable information you may provide in your use of the features of this site or app.
  2. Personally identifiable information

    On certain forms of this site or app, you may be asked to provide information about yourself or your account with us, either to identify yourself to us or to request a service from us. In each case, we will inform you what information is provided at your option and what information is required to complete the transaction or activity you are engaged in. If you are unwilling to provide this required information, you will be unable to complete the requested transaction.

Use and disclosure of information

The information you provide to us will be used to respond to requests you may make for services. Some or all of this information may be added to your permanent account record and may be used for research purposes.

In addition, we may use elements of this information in the following situations:

  1. We may transfer the information to Kentucky Power’s affiliates and subsidiaries, unless such transfer is prohibited by law;
  2. We may transfer the information as part of a merger, consolidation, acquisition, divestiture or other corporate restructuring (including bankruptcy);
  3. We may make the information available to third parties who are providing the product, service or information that you have requested (but not your password);
  4. We may make such information available to third parties who are providing services to Kentucky Power (for example, providing the information to third parties performing computer-related services for Kentucky Power);
  5. We may use the information to communicate with you about products and services that may be of interest to you.
  6. We may disclose the information if we form a good-faith belief that disclosure of such information is necessary to investigate, prevent, or take action regarding any illegal activities or regarding interference with the operation of our site or violation of its terms of use; or
  7. We may disclose the information if we believe that disclosure is required by law or regulation or in response to a subpoena or other order of a court or other governmental agency.

Kentucky Power uses Flurry Analytics Service (provided by Yahoo) in order to improve its mobile apps. Flurry’s privacy policy governs the use of this information.

Also, Kentucky Power reserves the right to share any aggregated information (i.e., non-personally identifiable information) with any third parties for any reason, unless prohibited by law.

We will not sell, rent or otherwise disclose the information we gather about you or your account to any third party, except as outlined in this Privacy Policy.


Kentucky Power takes reasonable steps to protect your personally identifiable information as it is transferred to us, through the use of Web technologies such as the Secure Sockets Layer and others. However, no Internet transmission of information is ever completely secure or error-free. In particular, e-mail sent to or from Kentucky Power may not be secure.

How to Reach Us

If you would like to update your personally identifiable information or if you have questions about this privacy policy, please contact us.

Changes to This Policy

Kentucky Power reserves the right to change this Privacy Policy at any time. If this Privacy Policy changes, the revised policy will be posted to this site. Please review this Privacy Policy before you provide any personally identifiable information through this site. Use of our web site after the posting of a revised privacy policy constitutes your consent to the revised policy.

This policy was last revised on December 13, 2017.

Close ×

Sign Up For Alerts

Subscribing to Kentucky Power alerts gives you instant notification for:

  • Billing & Payments - avoid late payments and disconnection
  • Outage Updates - find out if there's an outage at your address and when power will be back on

Win an Xbox One with Alerts!

Enroll in alerts to be eligible to win. Subscribing to I&M alerts gives you instant notification for:

  • Billing & Payments - avoid late payments and disconnection
  • Outage Updates - find out if there's an outage at your address and when power will be back on

Loading video...